Breville the Infuser Livret D'instructions page 28

All manuals and user guides at all-guides.com
TROUBLESHOOTING PAGE HEADER.....
PROBLEM
Machine does not
heat up.
STEAM/HOT WATER
light flashes when the
machine is turned
On.
Water does not flow
from the group head.
No hot water.
Espresso only drips
from the portafilter
spouts.
28
POSSIBLE CAUSES
• STEAM/HOT WATER
dial is not in the
STANDBY position.
• Machine has not reached
operating temperature.
• Water tank is empty.
• Water tank is not fully
inserted and locked into
position.
• Machine needs to be
decalcified.
• Coffee is ground too
finely and/or too much
coffee in filter basket
and/or over tamping.
• Coffee is ground too
finely.
• Too much coffee in the
filter basket.
• Coffee tamped too
firmly.
• Water tank is empty.
• Water tank is not fully
inserted and locked into
position.
WHAT TO DO
Turn the STEAM/HOT
WATER dial to the STANDBY
position. Machine will
commence heating.
Allow time for the machine to
reach operating temperature.
The POWER button light will
stop flashing and all button
lights on the control panel will
illuminate when ready.
Fill tank.
Push water tank down
completely to lock into place.
Refer to "Decalcifying",
page 24.
See below, "Espresso only drips
from the portafilter spouts."
Use slightly coarser grind.
Lower dose of coffee. As a
guide to dose, the top edge of
the metal cap on the tamper
should be level with the top
of the filter basket AFTER the
coffee has been tamped with
30-40lbs (15-20kg) of pressure.
Tamp between 30-40lbs or
15-20kg of pressure.
Fill tank.
Push water tank down
completely to lock into place.