Care And Cleaning - Dacor Renaissance HWO127 Mode D'emploi

WARNING
• Clean as instructed only the oven parts listed in this manual.
• To avoid dangerous fumes and surface/accessory damage,
use only the cleaning solutions specified in this manual.
• Before cleaning, ensure the oven is off and all parts are cool.
• Do not use abrasive/corrosive cleaners or applicators (e.g.,
steel wool, scouring pads) anywhere on the oven except as
instructed. Use only a sponge, soft cloth, fibrous or plastic
brush, or nylon cleaning pad on the oven surfaces.
• Do not use steam-clean the oven. Steam could penetrate the
electrical components and short the circuit.
• Do not use sharp objects (e.g., knife, metal spatula) to
remove heavy spills.
About Self-Clean Mode
• For best function and results, the oven chambers should
be cleaned regularly. The self-cleaning feature heats
the oven to very high temperatures to burn off surfaces
deposits on the oven interiors. The self-clean process
takes about 2 1/2 hours.
• Smoke emission is normal during the first few self-clean
cycles. The oven also emits popping sounds during self-
cleaning due to metal expanding/contracting as the oven
heats and cools.
• Self-clean mode will not function if the meat probe is con-
nected.
WARNING
• For less smoke and better efficiency, wipe up grease and
other food spills with a damp cloth before self-cleaning. (See
the cleaning instructions on this page.)
• Exterior oven surfaces willl be HOT during self-cleaning.
• To avoid product damage/ruin, remove the racks and any
foreign object from the oven during self-cleaning.
Using the Self-Clean Feature
IMPORTANT
• Double ovens: The control panel only allow one oven
chamber to be self-cleaned at a time due to the amount of
power consumed. You cannot cook in one oven when the
other is in self-clean mode.
• The oven lights do not operate while the oven is in self-clean
mode to protect them from damage.
• Self-clean will not work with the meat probe connected (the
meat probe symbol blinks to alert you to remove the probe).
1. Remove the racks, convection filter, all cookware, the
meat probe, foil, and all other loose objects from the oven
chamber. (See Pg. 13 for filter cleaning instructions.
2. Wipe the interior door surfaces outside the door gasket
with a vinegar-water solution, then wipe dry. Clean heav-
ily soiled areas with a plastic scouring pad.

CARE AND CLEANING

12
3. Clean the door gasket by dabbing it with a water-mild
soap solution.
CAUTION
• Carefully clean the door gasket to avoid compromising the tight
seal needed for best results and function.
• Trying to open the door after it has locked may damage the
door and latch.
4. Turn on kitchen fans or vents to help remove odors
during the self-clean cycle.
5. Shut the oven door, and touch Self-Clean.
6. Touch START.
The oven door locks automatically during self-cleaning to
prevent personal injury from the high temperature gener-
ated during self-cleaning. If the door is ajar, an error mes-
sage appears on the display. To clear the error, touch
CANCEL/SECURE, and wait one minute, then close the
door. When the error clears, restart the self-clean process.
The display shows the self-clean cycle status:
• The clean symbol indicates that self-clean is in
process.
• The lock symbol indicates that the door is latched.
• "ON" indicates that the heating elements are on.
To stop self-cleaning, touch CANCEL/SECURE. The oven
1
door remains locked until has cooled sufficiently. (The lock
symbol disappear from the display). The oven may still be
hot, so be cautious.
When self-cleaning is complete:
• The door latch releases when the inside has cooled down.
The clean icon, lock icon, and ON indicator disappear
from the display. The oven, however, is still HOT.
• Reinstall the convection filter before using the oven.
• A powdery residue may coat the oven floor after self-
cleaning—this is normal. When the oven is cool, wipe the
resideu with a damp cloth or sponge.
Self-Cleaning Tips
• If soil remains after self-cleaning, you may repeat the cycle.
• Self-clean the oven regularly to prevent soil buildup.
Setting Delayed Self-Cleaning
1. Prepare the oven for self-cleaning as instructed in the
previous procedure, and close the oven door.
2. Touch Self-Clean > START TIME.
3. Enter the desired start time (e.g., touch 1-2-3-0 for 12:30).
Maximum delay is 22 hr, 59 min.
4. Touch START.
DELAY appears on the display; the oven door locks. The
oven will start self-cleaning at the input time.
2
1 2