Correcting Faults - brennenstuhl Jet Light 38 W Mode D'emploi

Jet Light 38 W/55 W IP 54
6 CLEANING
Unplug before cleaning. For electrical safety reasons, the worklamp must be cleaned with
a dry cloth. Do not use strong detergents or chemicals (solvents, petrol, etc.) or coarse
sponges. Never dip the worklamp in water.
7

CORRECTING FAULTS

If the Jet Light is not functioning normally cross-check the following table of faults and
solutions.
PROBLEM
Jet Light is not lighting up
Jet Light is flashing
Socket is not functioning
Switch is not functioning
Important!
A damaged input cable can be replaced by the manufacturer or his/her service
representative.
Danger!
All other repairs on the worklamp can only be carried out by specialists.
Service-Address:
Hugo Brennenstuhl GmbH & Co. KG
D-72074 Tübingen
Tel.: 0 18 05 - 7 20 74-1 (14 ct./min on the German landline network)
Manufacturer:
Hugo Brennenstuhl GmbH & Co. KG
D-72074 Tübingen
www.brennenstuhl.com
All manuals and user guides at all-guides.com
CAUSE
1 No electricity or the electricity
has not been turned on
2 Plug contact is not intact
3 The switch is on "O"
4 The light has broken down
1 The starter is either loose or
faulty
2 The light is old or is not
functioning properly
1 No electricity, or it has not been
switched on
1 No electricity, or it has not been
switched on
2 Light is faulty
3 Starter is damaged
Instructions manual
SOLUTION
1 Check the electricity and switch
it on
2 Pull out the plug and push it
back in and or use another
socket
3 Turn the switch to "I"
4 Replace the light
1 Replace the starter
2 Replace the light
1 Make sure the electricity is
turned on
1 Make sure the electricity id
turned on
2 Replace the light
3 Change the starter
19