Correcting Malfunctions; Malfunctioning Analysis Coffee Module; Display Messages - BRAVILOR BONAMAT RLX Série Mode D'emploi

10. Carefully pour half of the Renegite solution
into the pouring opening, using a funnel.
11. Select a minimum number of cups using the
ã−button.
1
12. Press the / −button.
0
13. Wait for 2 minutes.
14. Carefully pour the remainder of the Renegite
solution into the pouring opening, using a
funnel.
15. Select a minimum number of cups using the
ã−button.
1.7

Correcting malfunctions

D See §1.6.1 of the "General user instructions".
1.7.1

Malfunctioning analysis coffee module

Symptom:
1. Descaling signal is flashing.
2. After descaling, the
descaling signal is still
flashing. flashing
3. The filter pan runs over.
4. The machine produces too
little coffee.
5. The machine produces too
much coffee.
1.7.2

Display messages

E1
The overflow protection was activated.
ECopyright Bravilor Bonamat B.V.
Bravilor Bonamat BV
LIST OF MALFUNCTIONS
Possible cause:
Too much scale in the machine.
Still too much scale in the
machine.
The filter pan spring is missing.
The set amount of water is too
small (P1).
The set amount of water is too
large.
DISPLAY MESSAGES
Possible cause:
1
16. Press the / −button.
0
17. Empty the jug or the airpot (module 1 or 6) or
drain the container using the draw−off tap
(module 5).
18. Have the normal coffee making process run,
without coffee, to rinse the machine.
19. In the meantime, empty the glass jug or the
airpot, or draw off the liquid from the
container.
20. Rinse the filter pan, jug, or airpot with hot
water.
Actions:
Run the descaling sequence on
the machine, see §1.6.3.
Descale the machine once
more.
Call in service.
Place the filter pan spring.
Raise P1, see §1.5.
Reduce P1, see §1.5.
Actions:
Check the supply hose for any kinks.
Check the water pressure at the same time.
Reset the system afterwards: set the
ON/OFF switch to the off position and then
switch it on again.
Call in service.
5