Troubleshooting Guide - Craftsman 919.672180 Manuel Du Propriétaire

6. Pull engine starter rope slowly
several times until antifreeze or
windshield washer fluid comes
out of high pressure hose con-
nection of pump.
7. Remove short hose from water
inlet of pump.
8. Install spark plug into spark plug
hole and tighten securely, then
reconnect spark plug wire.
PROBLEM
Engine will not
start
No or low
pressure
(initial use)
D30339

TROUBLESHOOTING GUIDE

CAUSE
1. No fuel.
2. Pressure builds up after
two pulls on the recoil
starter or after initial use.
3. Not choked.
4. Spark plug wire not
attached.
5. Choke lever in the
"Choke" position on a
"hot" engine or an engine
that has been exposed to
thermal heat for a long
period of time.
1. Wand not in high
pressure.
2. Low water supply.
3. Leak at high pressure
hose.
4. Nozzle obstructed.
5. Water filter screen
clogged.
9. Drain all water from high pressure
hose, coil it, and store it in cradle
of the pressure washer handle.
10. Drain all water from spray gun
and wand by holding spray gun in
a vertical position with nozzle end
pointing down and squeezing
trigger. Store in gun/hose holder.
11. Store chemical hose, high
pressure hose, spray gun, and
wand so they are protected from
damage, such as being run over.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
19- ENG
CORRECTION
Add Fuel.
Squeeze gun trigger to
relieve pressure.
Choke engine, place
engine in the choke
position.
Attach spark plug wire.
Move choke to the "No
Choke" position.
See How to Use Spay
Wand paragraph in the
Operation Section.
Water supply must be at
least 5 GPM @ 20 PSI.
Repair leak. Apply sealant
tape if necessary.
Clean nozzle with paper
clip or nozzle cleaning
tool, pour water into noz-
zle end to flush out ob-
struction.
Remove and clean filter.
D30339