Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7.
If you are applying a chemical or
cleaning solution, See How To
Apply Chemicals and Cleaning
Solvents in Operation section of
this manual.
8.
Turn water source on.
NOTE: Make sure water supply is
turned on.
9.
Move the choke control lever to
the CHOKE ON
the throttle control to the FAST
position. NOTE: No choke is
needed to start a warm engine.
Throttle
Control
serious injury or death!
Before performing any maintenance or repair, disconnect spark plug wire,
let engine cool and release all water pressure. The engine contains
flammable fuel. DO NOT smoke or work near open flames while
performing maintenance.
To ensure efficient operation and longer life of your pressure washer, a routine
maintenance schedule should be prepared and followed. If the pressure washer
is used in unusual conditions, such as high-temperatures or dusty conditions,
more frequent maintenance checks will be required.
D30339
D30339
D30339
position and
Choke
Control

MAINTENANCE

When performing maintenance, you may be exposed to hot
surfaces, water pressure, or moving parts that can cause
10. Pull starter grip slowly until you
feel resistance, then pull briskly.
Return starter grip gently. Pull
rope with a rapid full arm stroke.
Let rope rewind slowly. Repeat if
necessary.
pulls, pull the trigger to relieve the
pressure.
11. If the choke was used to start
the engine, move the choke lever
to the OFF position.
12. Depress trigger on gun to start
water flow. Release trigger to
stop water flow.
13. Adjust nozzle spray for the task
being performed. See How To
Use Spray Wand instructions in
this section.
with very hot engine muffler during
or immediately after use of your
pressure washer.
14- ENG
If the engine does
not start after two
DO NOT let hoses
come in contact

Publicité

Chapitres

Table des Matières
loading

Table des Matières