Troubleshooting Guide - Craftsman 919.672240 Guide De L'utilisateur

All manuals and user guides at all-guides.com
6. Pull engine starter rope slowly
several times until antifreeze or
windshield washer fluid comes
out of high pressure hose con-
nection of pump.
7. Remove short hose from water
inlet of pump.
8. Install spark plug into spark plug
hole and tighten securely, then
reconnect spark plug wire.

TROUBLESHOOTING GUIDE

PROBLEM
Engine will not
1.
start
2.
3.
4.
5.
6.
No or low
1.
pressure
(initial use)
2.
3.
4.
5.
9.
10. Drain all water from spray gun
11. Store chemical hose, high pres-
CAUSE
No fuel.
Pressure builds up after
two pulls on the recoil
starter or after initial use.
Not choked.
Spark plug wire not
attached.
Choke lever in the
"Choke" position on a
"hot" engine or an engine
that has been exposed to
thermal heat for a long
period of time.
Fuel valve closed
Wand not in high pres-
sure.
Low water supply.
Leak at high pressure
hose.
Nozzle obstructed.
Water filter screen
clogged.
19- ENG
Drain all water from high pressure
hose, coil it, and store it in cradle
of the pressure washer handle.
and wand by holding spray gun in
a vertical position with nozzle end
pointing down and squeezing
trigger. Store in gun/hose holder.
sure hose, spray gun, and wand
so they are protected from dam-
age, such as being run over.
CORRECTION
1. Add Fuel.
2. Squeeze gun trigger to
relieve pressure.
3. Choke engine, place
engine in the choke posi-
tion.
4. Attach spark plug wire.
5. Move choke to the "No
Choke" position.
6. Move the fuel valve knob
to the "Open" position.
1. See How to Use Wand
paragraph in the
Operation Section.
2. Water supply must be at
least 5 GPM @ 20 PSI.
3. Repair leak. Apply sealant
tape if necessary.
4. Clean nozzle with paper
clip or nozzle cleaning
tool, pour water into noz-
zle end to flush out ob-
struction.
5. Remove and clean filter.
D25083