Craftsman 919.672180 Manuel Du Propriétaire page 12

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The nozzle at the end of the multi-
adjustable spray wand can be rotated
to change the high pressure spray
pattern from a narrow jet to a 40º fan
shape, as shown. Markings have
been placed on the nozzle to help
you select the spray pattern.
For low pressure operation, extend
the nozzle of the multi-adjustable
spray wand as shown.
HOW TO APPLY CHEMICALS
AND CLEANING SOLVENTS
Applying chemicals or cleaning
solvents is a low pressure operation.
NOTE: Use only soaps and
chemicals designed for pressure
washer use. Do not use bleach.
To Apply chemicals:
1.
Press chemical hose onto barbed
fitting located near high pressure
hose connection of pump as
shown.
D30339
D30339
D30339
40º fan spray
narrow jet stream
low
pressure
Barb fitting
2.
Place other end of chemical hose
with filter on it into container
holding chemical/cleaning solution.
NOTE: The chemical/water ratio is
7:1, for every 7 gallons of water
pumped 1 gallon of
chemical/cleaning solution will be
used.
3.
Set multi-adjustable nozzle to low
pressure setting. See How To Use
Wand paragraph in this section.
4.
After use of chemicals, place
chemical hose into container of
clean water and draw clean water
through chemical injection system
to rinse system thoroughly. If
chemicals remain in the pump it
could be damaged. Pumps
damaged due to chemicals will not
be covered under warranty.
NOTE: Chemicals and soaps will not
siphon when spray wand is in the high
pressure setting.
TO SHUT DOWN
IMPORTANT: Read and understand
how to shut down the pressure
washer before operating.
1.
If you have applied chemicals,
place chemical hose into container
of clean water and draw clean
water through chemical injection
system to rinse system thoroughly.
NOTE: Failure to do so could
cause damage to the pump.
2.
Turn engine off by placing the
throttle control in the STOP
position.
NOTE: NEVER turn the water off
with the engine running.
3.
Turn water source off.
4.
Pull trigger on spray gun to
relieve any water pressure in
hose or spray gun.
5.
See Storage section in this
manual for proper storage
procedures.
12- ENG

Publicité

Chapitres

Table des Matières
loading

Table des Matières