Maytag MRT118FFF Manuel D'utilisation page 11

3. Remove door hinge hole plug from refrigerator door. Move to
opposite side hinge hole as shown below.
A. Door Hinge Hole Plug
4. Remove door handle sealing screws. Move to opposite side of
refrigerator door as shown.
A. Door Handle Sealing Screws
5. Remove door handle hole plug and discard. Replace on
opposite side with the door handle hole plug provided in the
Reversibility Kit located in the crisper.
6. Remove door stop. Move to opposite side of refrigerator door
as shown below.
A. Door Stop Screw
7. Refer to image in Step 2. Position refrigerator handle on
opposite side of the refrigerator door. First, drive top two
screws in handle first. Align lower portion of handle and drive
bottom screw into handle.
8. Tighten all screws. Set aside refrigerator door until bottom
hinge is installed on refrigerator.
9. Replace screw cover.
B. Door Stop
Style 2 - Contour Door Models
Graphics follow these instructions.
Door Hinge Cabinet
Hole Plug Hinge Hole
Plug
Dome Cap Dome Cap
Washer
Cabinet
1. Remove the three dome caps and the screws from handle
side and move them to opposite side.
2. Using the three 5/16" hex-head hinge screws, insert two
screws halfway into the holes, leaving space to insert the
Center Hinge.
3. Slide the center hinge, from the right, onto the screws, insert
the third screw, and tighten all screws completely.
NOTE: Make sure the washers are in place on both the top
and bottom pins of the center hinge.
A. 5/16" Hex-head hinge screws
4. Remove cabinet hinge hole plugs from the cabinet top and
move them to opposite side hinge holes as shown below.
A. Cabinet Hinge Hole Plugs
Setscrew Door Stop
Screw
Flat-Head
Shoulder
Handle
Screw
Screw
B. Washers
Shoulder
Screw
Washer
Door
Handle
Hole Plug
11