Reverse Doors And Hinges (Optional) - Maytag MRT118FFF Manuel D'utilisation

Reverse Doors and Hinges (optional)

IMPORTANT: If you want to reverse your doors so that they open
in the opposite direction, follow these steps. If you are not
reversing the doors, see "Replace Doors and Hinges."
Style 1 - Standard Door Models
Graphics follow these instructions.
Door Stop Dome Cap
Screw
Door Handle Flat-Head
Sealing Screw Handle Screw
Cabinet
1. Remove the three dome caps and the screws from handle
side and move them to opposite side.
A. Dome cap washers
B. Hex-head hinge screws
2. Remove cabinet hinge hole plugs from cabinet top and move
them to opposite side hinge holes as shown below..
A. Cabinet Hinge Hole Plugs
Freezer Door
1. Remove the screw cover.
2. Remove the freezer handle assembly as shown below. Keep
all parts together.
A. Screw Cover
B. Handle Screw
10
Cabinet Hinge Door Handle
Hole Plug Hole Plug
Dome Cap Door Hinge
Washer Hole Plug
C. Dome Caps
C. Freezer Handle
D. Flat-Head Handle Screw
3. Remove door hinge hole plug from freezer door. Move to
opposite side hinge hole as shown below.
A. Door Hinge Hole Plug
4. Remove the brand badge using the plastic tool (provided).
Replace it with the badge provided in the Reversibility Kit
located inside the crisper drawer. For proper placement, see
the Brand Badge Placement template (the last page of this
manual).
NOTEs:
� To avoid scratching the finish, do not use a sharp or
metallic object to pry the brand badge from the door.
� Rub a small amount of liquid dish soap over any adhesive
residue with your fingers. Rinse the door with warm water
and dry with a soft cloth.
5.
A. Door stop screw
6. Remove door stop. Move to opposite side of refrigerator door
as shown.
7. Refer to image in Step 2. Position freezer handle on opposite
side of the freezer door. First, drive the bottom two screws into
handle. Align upper portion of handle and drive top screw into
handle.
8. Tighten all screws. Set aside door until hinges and refrigerator
compartment door are in place.
9. Replace screw cover. Refer to image in Step 2.
Refrigerator Door
1. Remove the screw cover.
2. Remove refrigerator handle assembly as shown below. Keep
all parts together..
A. Flat-Head Handle Screw
B. Refrigerator Handle
B. Door stop
C. Handle Screw
D. Screw Cover