Federal Signal Fireball FB2LED-QC Instructions D'installation

Model FB2LED-QC
Fireball Quad-Color
®
LED Warning Light
UL and cUL Listed for Type 4X, IP66 environments.
IP69K compliant enclosure.
Installation and Maintenance Instructions
Warranty: This product's limited warranty can be found at www.fedsig.com/SSG-Warranty.
Limited
Safety Messages to Installers and Users
a licensed electrician and follow all safety instructions. Failure to do so may result in property
damage, serious injury, or death.
• Read and understand all instructions before installing or operating the equipment.
• To avoid electrical shock hazards, do not connect wires when power is applied.
• In order to be an effective warning device, this product produces bright light that can be
hazardous to your eyesight. The possibility exists that rapid flashing lights could induce
photosensitive epilepsy. Do not stare directly at the light.
FB2LED-QC is a high-powered, multi-
Overview:
colored, and multi-flash pattern LED signal that can
produce four different colors and three different
flash patterns in one unit. The available colors are
amber, blue, green, and red and the available flash
patterns include steady, 60 FPM, and 120 FPM. It is
available in 12-24VDC @ 0.32A-0.17A or 120-240VAC
@ 0.055A. The unit is UL/cUL Listed, Type 4X, IP66
for indoor/outdoor use. IP69K compliant. Certified
operating temperature: -40°F to 150°F (-40° to 66°C).
Unpacking the Device: After unpacking the device,
examine it for damage and verify parts. The unit comes with: (1) FB2LED-QC assembled unit with
flying leads, (1) Panel mount gasket, and (3) No. 8 x 1/2" panel mounting tapping screws. If a part is
missing or appears damaged do not attempt to install. Contact Federal Signal Customer Support at
+1 708-587-3587 or iordersup@fedsig.com.
Mounting the Device: Model FB2LED-QC comes standard to mount on a flat (horizontal or
vertical) surface or 1/2" NPT threaded pipe. Vertical wall (LWMB2 and Type 4X LSWB) or corner
(LCMB2) mounting accessories are sold separately.
• Pipe Mounting – Model FB2LED-QC can be pipe mounted on a 1/2" NPT pipe. Feed wires
through pipe and turn clockwise to tighten. Recommended tightening torque is 5-ft-lbs (6.8 N-m).
• Surface/Panel Mounting – Using provided gasket as a template, mark three mounting holes
and center hole for wiring. Drill or punch 0.188" (5.0mm) diameter holes for mounting and a
.88" (22.0mm) for wiring. Set base on gasket, feed wires through center hole, and attach to the
mounting surface using provided No. 8 tapping screws from the underside.
: This product should be installed to code by
18AWG
Lead Wires
Impact Resistant
4.10"/ 104 mm
Fresnel Lens
LED PCBA
Die-cast
Metal Base
1/2" NPT Entry