Technical Specifications - Klarstein Fine Dinesty Mode D'emploi

MICROWAVE RADIATION!
It is hazardous for anyone, other than a qualifi ed service technician, to carry out any service for repairing
operation which involves removal of any cover which gives protection against exposure to microwave
energy.
The temperature of accessible surfaces may be high when the appliance is operating
The high voltage capacitor remains charge after disconnection; short the negative terminal of H. V capa-
citor to the oven chassis (use a screwdriver) to discharge before touching.
During servicing below listed parts are liable to be removed and give access to potentials above250V to
earth.
1. Magnetron
2. High voltage transformer
3. High voltage capacitor
4. High voltage diode
5. High voltage fuse
The following conditions may cause undue microwave exposure during servicing.
Improper fi tting of magnetron;
Improper matching of door interlock, door hinge and door;
Improper fi tting of switch support;
Door, door seal or enclosure has been damaged.
If the door or door seals are damaged, the oven must not be operated until it has been repaired by a
competent person;
It is hazardous for anyone, other than a qualifi ed service technician, to carry out any service for repairing
operation which involves removal of any cover which gives protection against exposure to microwave
energy.
Liquids or other foods must not be heated in sealed containers since they are liable to explode;
The manufacturer of this product is Chal-Tec GmbH, Wallstraße 16, 10179 Berlin.
This product complies with the requirements of the directives
SERVICING SAFEGUARDS
Technical specifi cations
22