Tripp-Lite PDU360AT6G60 Manuel De L'utilisateur page 18

5. Using the Digital Display
5.2 Navigating Config Menus and Submenus (Configuration)
While in any Display Menu, press and hold Mode button for 2 seconds to enter the first Config
menu. Press Mode button to cycle to the next Config menu. Press and hold Mode button for 2
seconds to switch to Display menus.
Temperature Unit Options
C – F
2 Seconds
C – F
Preferred Source Selection
P S S
2 Seconds
P S S
Auto Scroll Enable/Disable
2 Seconds
16-01-031-933588.indb 18
All manuals and user guides at all-guides.com
Hold Enter button for 2 seconds to switch
between options. The letter in the 2-digit
F
display indicates the selected unit, C for
Celsius and F for Fahrenheit.
C
Hold Enter button for 2 seconds to switch
between Source A and Source B. The letter in
A
the 2-digit display indicates the selected source.
Note: If both sources are available, the unit will
transfer to the preferred source immediately once the
setting is changed.
When enabled, the Auto Scroll function cycles
through the output load circuit currents
(C1, C2, C3) menus in 4-second intervals.
"y" indicates the function is enabled; "n"
indicates that it is disabled. Pressing any
button interrupts the auto scroll function,
allowing the user to navigate between menu
options. If no button is pressed, there is a 10
second timeout and auto scroll will resume
from the current menu.
18
3/22/2016 4:14:24 PM