Operating Modes; Starting Operation - Bosch GHO 10-82 Professional Notice Originale

All manuals and user guides at all-guides.com
OBJ_BUCH-447-001.book Page 12 Monday, October 8, 2007 11:18 AM
12 | English
Using Conversion Kits
Converting from HSS to TC
With the conversion kit 2 607 001 399 (see ac-
cessories), planers equipped with HSS planer
blades can be converted to TC planer blades.
– Loosen and remove the clamping jaw 12.
– Slide the planer-blade retainer 16 together
with the planer blade 15 out of the guide
groove 14 of the blade drum 13.
– Insert the conversion kit 2 607 001 399 into
the guide groove 14.
– Reattach the clamping jaw 12 and screw in
the fastening screws 11, but do not tighten
them yet.
– Insert the TC planer blade from the side into
the planer blade seat.
– Each planer blade must be assembled and
aligned centered to the planer base plate 8.
Afterwards, tighten the three fastening
screws 11 with the Torx key 10, ensuring the
correct tightening sequence (
clamping jaw 12.
Converting from TC to HSS
With the conversion kit 2 607 001 398 (see ac-
cessories), planers equipped with TC planer
blades can be converted to HSS planer blades.
– Unscrew the 3 fastening screws 11 with the
Torx key 10 and remove the clamping jaw 12.
– Slide the planer-blade retainer 16 together
with the planer blade 15 out of the guide
groove 14 of the blade drum 13.
– Insert the conversion kit 2 607 001 398 into
the guide groove 14 and align it centered to
the planer base plate 8.
– Reattach the clamping jaw 12 and tighten the
three fastening screws 11 with the Torx key
10. Ensure the correct tightening sequence
( ) on the clamping jaw 12.
1 609 929 M02 | (8.10.07)
Operation

Operating Modes

Adjusting the Planing Depth
With the adjustment knob 2, the planing depth
can be adjusted variably from 0–1.0 mm using
the planing depth scale 1 (scale graduation =
0.2 mm).
Park Rest (see figure N)
The park rest 29 allows the machine to be set
down directly after operation, without danger of
damaging the working surface or the planer
blade. While planing, the park rest 29 is tilted up-
wards thus enabling full contact of the rear part
of the planer base plate 8.

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
) on the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V can
also be operated with 220 V.
Switching On and Off
To start the machine, press the On/Off switch 5
and keep it depressed.
To lock the pressed On/Off switch 5, press the
lock-on button 4.
To switch off the machine, release the On/Off
switch 5 or when it is locked with the lock-on but-
ton 4, briefly press the On/Off switch 5 and then
release it.
0 601 594 037:
To start the machine, first push the lock-off but-
ton for the On/Off switch 4 and then press the
On/Off switch 5 and keep it pressed.
To switch off the machine, release the On/Off
switch 5.
Note: For safety reasons, the On/Off switch 5
cannot be locked; it must remain pressed during
the entire operation.
Bosch Power Tools