Operating Modes - Bosch GST 500 PE Professional Notice Originale

Selecting a Saw Blade
An overview of recommended saw blades can be
found at the end of these instructions. Use only
T-shank saw blades. The saw blade should not be
longer than required for the intended cut.
Use a thin saw blade for narrow curve cuts.
Inserting the Saw Blade (see figure A)
Before inserting the saw blade 9, set the adjust-
ing lever for orbital action 6 to setting III .
– Press the orange pushbutton in the rotatable
top handle 1 down until it can be felt to en-
gage.
– Turn the rotating handle 1 approx. three turns
in the direction of the arrow.
– Insert the saw blade 9 lateral to the cutting di-
rection into the stroke rod 11.
– Turn the saw blade 9 so that the toothing fac-
es toward the cutting direction. Pull the saw
blade 9 a little downward until it engages.
– Turn the rotating handle 1 in the direction of
the arrow until a click can be heard.
– Push up the orange pushbutton at the rotata-
ble top handle 1 again to the starting position.
Check the tight seating of the saw blade. A
loose saw blade can fall out and lead to inju-
ries.
Splinter Guard (see figure B)
Before any work on the machine itself, pull
the mains plug.
The splinter guard 12 (accessory) can prevent
fraying of the surface while sawing wood. The
splinter guard can only be used for certain saw
blade types and only for cutting angles of 0°.
When sawing with the splinter guard, the base
plate 7 must not be moved back for cuts that are
close to the edge.
Press the splinter guard 12 from the bottom into
the base plate 7.
Bosch Power Tools
All manuals and user guides at all-guides.com
Operation

Operating Modes

Orbital Action Settings
The four orbital action settings allow for optimal
adaptation of cutting speed, cutting capacity and
cutting pattern to the material being sawed.
The orbital action can be adjusted with the ad-
justing lever 6, even during operation.
Setting 0
Setting I
Setting II
Setting III
The optimal orbital action setting for the respec-
tive application can be determined through prac-
tical testing. The following recommendations ap-
ply:
– Select a lower orbital action setting (or switch
– For thin materials such as sheet metal, switch
– For hard materials such as steel, work with
– For soft materials and when sawing in the di-
Adjusting the Cutting Angle (see figure C)
The base plate 7 can be swivelled by 45° to the
left or right for mitre cuts.
– Loosen the screw 14 and lightly slide the base
– For adjustment of precise mitre angles, the
– Afterwards, push the base plate 7 to the stop
– Tighten the screw 14 again.
The splinter guard 12 can not be inserted for mi-
tre cuts.
Before any work on the machine itself, pull
the mains plug.
No orbital action
Small orbital action
Medium orbital action
Large orbital action
it off) for a finer and cleaner cutting edge.
the orbital action off.
low orbital action.
rection of the grain, work with maximum or-
bital action.
plate 7 in the direction of the saw blade 9.
base plate has adjustment notches on the left
and right at 0° and 45°. Swivel the base plate
7 to the desired position according to the
scale 13. Other mitre angles can be adjusted
using a protractor.
toward the mains cable.
English | 19
2 609 932 532 | (25.7.07)