Option Menu - Sony MFM-HT75W Mode D'emploi

x Adjusting the picture's position manually
(H Center /V Center) (for PC 2 only)
If the picture is not in the centre of the screen, adjust the picture's
centring as follows.
1 Set the resolution to 1280 × 768 (MFM-HT75W), or
1280 × 1024 (MFM-HT95) on the computer.
2 Load the CD-ROM.
3 Start the CD-ROM, select the area and model, and
display the test pattern.
For Windows
Click [Utility] t [Windows]/[Win Utility.exe].
For Macintosh
Click [Utility] t [Mac]/[Mac Utility].
4 Press the MENU button.
The main menu appears on the screen.
5 Press the M/m buttons to select
press the OK button.
The "Screen" menu appears on the screen.
6 Press the M/m buttons to select "H Center" or "V
Center" and press the OK button.
The "H Center" adjustment menu or "V Center" adjustment
menu appears on the screen.
7 Press the M/m buttons to centre the test pattern on
the screen.
8 Click [END] on the screen to turn off the test pattern.
26

Option menu

You can adjust the following items using the "Option" menu.
• PIP
• Teletext
• Input Sensing
• Language
• Menu Position
• Menu Lock
• Demo Mode
• All Reset
x Setting "PIP" (Picture In Picture) (for PC 1/
PC 2 only)
When the "PIP Setting" menu is set to "PIP On," pictures from
two input sources are displayed on the screen at the same time.
The main picture is displayed in full size, and the sub picture is
displayed smaller in the corner of the screen. Also, you can
(Screen) and
choose either the sound from the main picture or the sub picture.
Notes
• When using the "PIP" function, if you switch the input using the
button or the input select buttons, the "PIP" function may be released.
If it happens, the input source that you have selected fills the entire
screen. To use the "PIP" function again, set the "PIP Setting" menu to
"PIP On" using the menu system or select "PIP On" by pressing the
• When the "Input Sensing" menu in the "Option" menu is set to "On,"
if the computer that is selected for main picture input enters the power
saving mode, the display try to detect a signal from the other computer
input and display it, if available. At this time, the "PIP" function will be
released. To use the "PIP" function again, set the "PIP Setting" menu
to "PIP On" using the menu system or select "PIP On" by pressing the
Tip
You can also switch the "PIP" setting by pressing the
repeatedly.
To switch the PIP function on and off
1 Press the MENU button.
The main menu appears on the screen.
2 Press the M/m buttons to select
press the OK button.
The "Option" menu appears on the screen.
3 Press the M/m buttons to select "PIP" and press the
OK button.
4 Press the M/m buttons to select "PIP Setting" and
press the OK button.
Option
button (page 16).
button (page 16).
DVI-D: PC 1
PIP :
Teletext :
Input Sensing : On
Language : English
Menu Position
Menu Lock : Off
Demo Mode : Off
All Reset
1280 × 1024/60 Hz
Select Set Exit
OK MENU
button
(Option) and