Video Signal Loss - Abus TVHD80120 Notice D'utilisation

Camera
Parameter
Full Screen Monitoring
Audible Warning
Notify CMS
Send E-Mail
Trigger alarm output

Confirm the settings by clicking Apply and leave the
menu with OK

Video signal loss

Select the camera channel under "Camera".
Set the checkmark for the alarm in the event of a "Video
Loss".
The DVR triggers an temper detection alarm if the func-
tion is enabled. The alarm behavior can be configured by
using the button "Handling".
All manuals and user guides at all-guides.com
Notification
The camera is displayed as
a full-screen picture in live
cast
The device emits a repeat-
ing tone
Sends an alarm signal to a
PC with ABUS CMS soft-
ware. The software must be
enabled and the recorder set
to surveillance mode on the
PC.
An e-mail is sent to a spe-
cific e-mail address
See page 46
Armin Schedule
Select the TAB Arming Schedule.
Here you set the times when the reactions in the TAB
Reaction are triggered.
1. Select the day and enter the schedule.
Note
You can define up to 8 time periods (each from
00:00 to 00:00). The times in the individual peri-
ods must not overlap.
2. Select whether the settings should be applied to all
days of the week with using Copy.
3. Confirm the settings by clicking Apply and leave the
menu with OK.
Handling
Click on the TAB Handling.
Here you can configure the behavior of the recorder during
a detected event (for example: motion got detected) by
clicking the respective check box.
102