First Use; Configuration - Velleman CTC1000 Mode D'emploi

When the control panel asks you to key in ENTER CODE or P-CODE, please enter your user pin code.
When the display panel asks you to key in M-CODE, please enter your master code.
For details about the pin code, see section 7.4 Pin code.
•
• For details about the master code, see section 7.7 Master Code.
6.5

First use

Assuming you have found a suitable location:
1. Apply the AC power to the control panel. You will hear a long beep. Alarm On will be displayed on the first
line and 00:01 01 Jan displayed on the second line of the screen indicating the system is in Away Mode
(this is the default Mode)
2. Press button 1 on the keypad.
3. Key in the pin code for user 1 (default code is 1234) within 30 seconds.
You can press to clear the code.
4. Press the OK key (within 30 seconds).
You will hear 2 short beeps and the display will show:
The system is now in alarm off mode.
5. Wait for 2 to 3 minutes for the system to read it status. If the yellow LED turns on, it indicates that there is
an error. Refer to section 14 for details.
Notes
The control panel has a screen saver function.
•
The Alarm off message will be displayed for 180 seconds. After that, the display shows only current date
and time.
7.

Configuration

To enter Program mode:
1. Make sure the alarm is off (see section 11.4).
2. Press the # key. The display shows:
3. Within 30 seconds, key in 1234 (default User1 pin code) and press OK.
The display shows:
4. Within 30 seconds, enter 1111 (default Master Code) and press OK.
For 2 seconds, the display shows:
5. Then the program menu will be displayed:
It is highly recommended to change the User 1 pin code and the master code on first use.
Cursor
• The cursor is indicated by a flashing dot in the left upper corner.
Use the keys  and  to move the cursor.
•
Press OK to confirm.
•
V. 04 – 11/02/2016
CTC1000
6 ©Velleman nv