Velleman CTC1000 Mode D'emploi page 25

1. Enter Program mode and select SMS Editor from the menu.
The Edit Screen appears.
2. Enter an sms message (up to 16x4 characters).
For information about entering text, see section 17.
3. Press OK.
4. Select Save and press OK to confirm.
SMS Keyword
The control panel supports remote commands sent from a mobile phone to the system. Before sending remote
commands, you will first need to enter a password called SMS keyword..
To change the pin code for remote commands:
1. Enter Program mode, select SMS Keyword from the menu and press OK.
2. Key in a code between 1 and 10 characters long and press OK. This code must be different from the user
code.
3. Repeat the code and press OK.
Country Code
The display format of the telephone number (with or without country code) may vary depending on the mobile
phone provider.
If your mobile phone displays numbers without the country code, you can ignore this section.
If your mobile phone displays numbers with the country code, you need to change a setting in the control
panel.
You can ask this to your provider or test it yourself as follows:
1. Insert the SIM card you will use for the control panel in a mobile phone.
2. Turn on the phone.
3. Make sure the number is not assigned to any contact on your phone.
4. Send an sms message to the same number.
o If your mobile phone displays numbers without the country code (for example 01234567890), you can
ignore this section.
o If your mobile phone displays numbers with the country code (for example +321234567890), proceed
as follows.
5. On the control panel, enter Program mode, go to Country Code and press OK.
6. Enter the country code of your country.
Example: if the number displayed on your phone was +321234567890, type 32 (without the '+').
7. Press OK.
8. In the Replacement screen, key in 0.
V. 04 – 11/02/2016
CTC1000
25 ©Velleman nv