Velleman CTC1000 Mode D'emploi page 34

2. The screen will display
Fault Dsp
Arm
with the cursor next to Fault Dsp.
3. Press OK key to select Fault Dsp.
All the errors are listed.
4. Use the & keys to move the cursor up or down.
5. After viewing all the errors, press
Clear Fault
Dsp (OK?)
6. If the error has been corrected, press OK.
The error will be cleared and the screen returns to Alarm off.
Notes
If the error has not been corrected, the display will not be cleared. It will appear again while you try to arm
•
the system and the error prevents the system from being armed. The error display can be cleared only
after the error has been corrected.
Even when the error message is cleared, the error will still be retained in the log.
•
14.2 Error Response
• When an error is detected, in addition to the error display, the control panel will also respond depending on
the nature of the event.
Except for sabotage alarms, the control panel and external sirens will not sound audible siren for error.
•
In all modes, when Panel AC power failure or tamper trigger happens, the control panel will send error
•
reports by SMS. For all other errors, the control panel will NOT send error report by SMS.
AC Power fail
control panel low battery
sensor low battery
panel sabotaged
sensor sabotaged
sensor out-of-order
V. 04 – 11/02/2016
CTC1000
key, a prompt message is displayed.
The yellow LED will light and the error message will be
•
displayed.
The panel will report the error by SMS to the first telephone
•
number in all modes within 15-30 minutes.
Once AC Power is restored, the panel also will report the restore
•
event by SMS to the first telephone number within 15-30
minutes.
Any time the system detects battery Low on the panel, yellow
•
LED will light while this error message can be viewed on LCD
under Fault Display.
• When control panel is powered by an AC adapter, the control
panel is incapable of detecting low battery condition.
• If the low battery is detected on any sensor, yellow LED will light
up at any time. The error message can be viewed on LCD under
Fault Display in the user menu.
If the Tamper switch on the control panel is triggered, yellow
•
LED will light. The error message can be viewed on LCD under
Fault Display in the user menu.
In addition, the panel will report the error by SMS to the first
•
telephone number in all modes.
If the tamper switch on the PIR sensor, door contact, remote
•
keypad, or outdoor siren is triggered, the yellow LED will light.
The error message can be viewed on LCD under Fault Display in
the user menu.
In addition, the panel will report the error by SMS to the first
•
telephone number in all modes.
The siren will sound alarm for tamper-trigger according to the
•
Tamper Alarm setting (see section Tamper Alarm in chapter 8).
When the control panel has not received the supervisory signal
•
from each individual PIR sensor or door contact, etc. for a period
(according to the setting of the Supervision), the yellow LED on
34 ©Velleman nv