Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Use the Frozen Dessert Maker to
produce different flavoured ice-creams
and sorbets.
This appliance conforms to EC
Regulation 1935/2004 on materials
and articles intended to come into
contact with food.
Before using for the first time
1
Wash the parts: see 'Cleaning'.
2
Twenty-four hours in advance, place
the freezing bowl into a freezer.
3
Prepare the ice cream or sorbet mix
(see Recipe Ideas). If necessary, allow
the mix to cool in a refrigerator.
Key
Splashguard
1
Paddle Assembly
Paddle upper
2
Locking nut
3
Spring
4
Paddle lower
5
Freezing bowl
6
Adaptor Ring Assembly
Adaptor ring
7
A - Adaptor ring seal
8
B - Adaptor ring seal
To Assemble Your Stirring
Paddle
Refer to Illustrations
1
Drop the spring into the paddle
lower part.
2
Slide the locking nut onto the
paddle part upper. Turn clockwise to
secure in place.
3
Place the paddle upper part over
the spring and press down.
4
With the paddle upper part pressed
down, turn the locking nut clockwise
to secure into place.
To disassemble reverse the above
procedure.
–
A
D
To Assemble Your Bowl
Adaptor Ring
Refer to Illustrations
Your attachment is supplied with two
adaptor ring seals. Please ensure the
correct seal is fitted before using the
attachment.
Adaptor Ring Seal A (Black)
Adaptor Ring Seal B (Grey)
For machines KVL65, KVL85 and
KWL90 use seal B, for all other models
use seal A. (Please note: The adaptor
ring will be supplied with seal B
fitted).
1
Place the rubber seal onto the
adaptor ring with the thicker edge
uppermost.
2
For correct seal assembly, align the
rubber blocks on the rubber seal
with the cut outs on the adapter
ring.
To Assemble Your Frozen
Dessert Maker
Refer to Illustrations
1
Prior to using the attachment
remove any heat/head shield and
splashguard already fitted.
2
Fit the adaptor ring assembly to the
mixing bowl by pushing down to
secure.
3
Add the freezer bowl direct from
the freezer.
Line up the guides on the freezer
bowl with the cut outs in the
adapter ring. Drop the freezer bowl
into place.
Note: The splashguard cannot be fitted
if the freezer bowl has not been fitted
correctly.
4
Insert the paddle. (Ensure that the
paddle part upper does not knock
against the bowl tool socket of your
stand mixer).
5
Fit the splashguard and push down
to secure into place.
4
–
E
F
–
G
L
Publicité
Table des Matières
