Valor G4 Guide D'installation page 2

Installation
1. Secure the backing plate (799BPB-1, 799PBP-2 or
799BPB-3 sold separately) to the appliance's outer
case from the inside as indicated (2 screws per side).
Note: You may need to remove the side shrouds to
fix the plate.
2. Identify the left and right door panels and their top
and bottom using the image below. On the left panel,
the notch in the rear flange of the panel is at the top.
The space between the rear flange and the edge
of the panel is wider at the top than at the bottom
of the panel as shown below.
Left door panel
Front view Rear view
2
3. Insert the top pin of the left door panel in the hole
4. Lift the panel as far as possible and insert the bottom
5. Install the right door panel the same way.
6. Hook the barrier screen front to the backing plate as
TOP of door:
this space is
wider
TOP of door:
notch in the
rear flange
BOTTOM of door:
this space is
narrower
at the top of the left shroud already installed on the
appliance.
pin in the hole at the bottom of the shroud. The
panel should rotate freely.
indicated.
Note: The barrier screen front, when hooked to
the backing plate, protrudes slightly in front of the
plate.