Accessories; Technical Specifications - Kärcher BD 38/12 C Bp Mode D'emploi

Fault
Insufficient cleaning
result
Brush does not turn Pull the safety switch towards the steering wheel.
The appliance can be equipped with vari-
ous accessories depending on the cleaning
Description
Disk brush, white
Disk brush, red (medium,
standard)
Disk brush, black (hard)
Disk brush, natural (white)
Pad driving disk
Pad, microfibre
Pad, black
Pad, green
Pad, red
Diamond pad, white
Diamond pad, yellow
Diamond pad, green
Fill hose
Suction lip kit
Vacuum bar
Power
Nominal voltage
Battery capacity
Battery type
Average power con-
sumption
Suction engine output
Brush engine output
22
Remedy
Check the brush type and the detergent for their suitability.
Check the brushes for wear, replace if required.
Check the brush for blockage by foreign objects; remove the foreign
objects.
Switch off the switch for the brush drive, wait for a short period of
time, switch the switch back on.

Accessories

Part no.:
6.907-154.0 For polishing and cleaning sensitive floors.
6.907-151.0 For cleaning slightly dirtied or sensitive floors.
6.907-152.0 For cleaning heavily dirtied floors.
6.907-153.0 For polishing floors.
6.907-150.0 For intake of pads.
6.905-060.0 Especially suited for the cleaning of linoleum
6.369-001.0 Deep cleaning of PVC, vinyl, synthetic resin
6.369-002.0 Maintenance cleaning of all water-resistant
6.369-003.0 Deep cleaning of linoleum, tiles, clinker,
6.371-250.0 For polishing floors.
6.371-251.0 For removing fine scrapes.
6.371-235.0 For cleaning heavily dirtied floors.
6.680-124.0 For filling the fresh water tank
4.037-059.0 As replacement
4.037-067.0 As replacement

Technical specifications

V 25,9
Ah 22
(5h)
Li-ion
W 500
W 280
W 260
task. Please request our catalogue or visit
us on the Internet at www.kaercher.com.
Description
and fine stone tiles.
coatings, dark marble, granite, terrazzo,
ground smooth.
floors.
glazed, stoneware.
Operating temperature
range
Vacuuming
Cleaning power, air
quantity
Cleaning power, nega-
tive pressure
Cleaning brushes
Working width
Brush diameter
– 9
EN
°C 0...40
l/s 20
kPa 8
mm 380
mm 380