Faults With Display; Accessories - Kärcher BD 50/50 C Bp Classic Mode D'emploi

Display Correction
ERR B Check if foreign objects block the brush; remove foreign object if required.
ERR T Call customer service.
LOW BAT Charging battery
ERR TEMP Allow device to cool down.
HANDS OFF Release the safety switch and wait until the operating hours or the battery status are displayed. Then operate
the safety switch again.
ERR REL Set the programme selector switch to "OFF", release the safety switch, wait for 3 seconds, restart.
If the event recurs, call Customer Service.
ERR PWM Call customer service.
Failure Correction
Appliance cannot be Turn the program selection switch to the desired programme.
started
Operate the safety switch.
Insert battery plug.
Check battery; charge it if required.
Make sure that all battery terminals are connected.
Insufficient water quan- Check fresh water level, refill tank if necessary.
tity
Increase the water volume on the regulating knob for water volume.
Clean sieve.
Insufficient vacuum per- Clean the seals between waste water tank and cover and check for tightness, replace if required.
formance
Wastewater reservoir is full; shut off the appliance and empty the wastewater reservoir
Clean the fluff filter.
Clean the vacuum lips on the vacuum bar, replace if required
Check if the cover on the dirt water discharge hose is closed
Check the setting of the vacuum bar.
Check suction hose for blockages; clean if required.
Check the suction hose for tightness; replace if required.
Insufficient cleaning re- Check the brushes for wear, replace if required.
sult
Brush does not turn Check if foreign objects block the brush; remove foreign object if required.
If over-current switch in the electronics system has been triggered, turn programme selection switch to "OFF".
Afterwards, set it back to the desired programme.
Vibrations during clean- You might need to use a softer brush.
ing
In case of faults that cannot be remedied using the table below please contact the customer service.
Description
Disk brush, red (medium, standard)
Disk brush, natural (white)
Disk brush, black (hard)
Driver plate pad
Pad, red (medium soft)
Pad, green (medium hard)
Pad, black (hard)
Pad, beige (light grain)
Pad, beige (natural hair proportion)
Suction bar, 850 mm, straight
Suction bar, 850 mm, bent
Set homebase box

Faults with display

Faults without display on the console

Accessories

Part no.:
4.905-026.0 For the use with all common cleaning tasks.
4.905-027.0 Made of natural fibres for spot cleaning and polishing.
4.905-029.0 For heavy soiling and for deep cleaning. For robust floorings
4.762-534.0 For cleaning with pads. With quick change coupling and center
6.369-079.0 For cleaning and cleanering of all floors.
6.369-078.0 For cleaning heavily soiled floors and for deep cleaning.
6.369-077.0 With stubborn soiling and for deep cleaning.
6.369-468.0 For polishing and refreshing of hard and flexible floorings.
6.371-146.0
4.777-401.0
4.777-411.0
4.035-406.0
EN
-
Description
only.
lock.
7 17