Installation And Start-Up - AL-KO Solo MULTITOOL MT 42 Traduction De La Notice D'utilisation Originale

Masquer les pouces Voir aussi pour Solo MULTITOOL MT 42:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34

Installation and start-up

strength, changes in the colour or condition
of the skin. Normally these conditions affect
the fingers, hands or pulse. The risk increas-
es at low temperatures.
Take long breaks during your working day so
you can recover from the noise and the vibra-
tions. Plan your work in such a way that the
use of appliances that generate strong vibra-
tions is spread over several days.
If you notice an unpleasant sensation or disc-
olouration of the skin on your hands when us-
ing the tool, stop work immediately. Take suf-
ficient work breaks. Without sufficient breaks,
a hand/arm vibration syndrome can occur.
Minimise your risk of being exposed to vibra-
tions. Maintain the tool according to the in-
structions in the operating instructions.
If the tool is used frequently, contact your
dealer to purchase anti-vibration accessories
(e.g. handles).
Avoid working with the tool at temperatures
below 10 °C. Define how the vibration load
can be limited in a work plan.
3.8.3
Noise pollution
A certain level of noise exposure from this appli-
ance is inevitable. Carry out noisy work at ap-
proved and specified time periods. Observe rest
periods as necessary and restrict the duration of
the work to a minimum. For your personal protec-
tion and protection of persons in the vicinity, ap-
propriate hearing protection must be worn.
4 INSTALLATION AND START-UP
4.1
Attaching the carrying belt to the basic
appliance
See "Multitool MT 42 – basic appliance" operat-
ing instructions.
4.2
Putting the attachment on the basic
appliance
See "Multitool MT 42 – basic appliance" operat-
ing instructions.
5 OPERATION
CAUTION!
Danger of burns
The gearbox housing becomes hot
during operation.
Do not touch the gearbox housing.
2500112_b
5.1
Turning the cutter head (02, 03)
The cutter head can be adjusted stepwise be-
tween -180° and +45° (02). This means it can be
adjusted as required for the work (03/a, 03/b).
WARNING!
Danger of cutting injuries
Danger of cutting injuries when reaching
into the cutting blade.
Always switch off the appliance be-
fore turning the cutter head.
1. Press and hold the unlock button (02/1).
2. Turn the cutter head (02/2) until it engages in
the required position.
3. Release the unlocking button (02/1).
5.2
Pulling off the protective cover (04)
1. Before switching on the appliance, pull the
protective cover (04/1) off the cutting blade
(04/2).
5.3
Switching the appliance on and off
See "Multitool MT 42 – basic appliance" operat-
ing instructions.
5.4
Oiling the cutting blade (05)
WARNING!
Danger of cutting injuries
Danger of cutting injuries when reaching
into the cutting blade.
Always switch off the appliance be-
fore oiling the cutting blade.
While working, perform the following tasks at reg-
ular intervals:
1. Oil the cutting blade (05/1) with environmen-
tally friendly lubricating oil (05/2).
This enables the cutting blade to run more easily,
it does not become hot and the battery life in-
creases.
19

Publicité

Table des Matières
loading

Table des Matières