Noise Pollution; Installation And Start-Up; Installing The Guard Plate (02); Installing The Hand Grip - AL-KO GTA 36 Li Traduction De La Notice D'utilisation Originale

Installation and start-up

■
If the device is used frequently, contact your
dealer and obtain anti vibration accessories if
necessary (e.g. grips).
■
Avoid working with the device at temperat-
ures below 10 °C. Define how the vibration
load can be limited in a work plan.
3.7.3

Noise pollution

A certain level of noise exposure from this device
is inevitable. Carry out noisy work at approved
and specified time periods. Observe rest periods
as necessary and restrict the duration of the work
to a minimum. For your personal protection and
protection of persons in the vicinity, appropriate
hearing protection must be worn.
4 INSTALLATION AND START-UP
4.1

Installing the guard plate (02)

1. Insert the guard plate (02/01) onto the cutter
head (02/02) (02/a).
2. Screw in the fastening screws (02/03) to se-
cure the guard plate against falling down (02/
b).
4.2

Installing the hand grip

See operating instructions of the basic appliance.
4.3 Putting the attachment on the basic
appliance
See "Multitool MT 36 Li – basic appliance" oper-
ating instructions.

5 OPERATION

Switch on the machine before approaching the
grass to be cut. Thus, the cutting line reaches the
maximum speed of rotation.
5.1 Fold down the protective bracket (03)
1. Tilt the protective bracket (03/1) downwards
by hand (03/a) until it engages in the hori-
zontal position (03/b).
5.2

Switching the appliance on and off

See "Multitool MT 36 Li – basic appliance" oper-
ating instructions.
5.3 Prolonging the cutting line during
operation (04)
The cutting line shortens during operation and
frays out.
442104_a
1. Tap (04/a) the spool head (04/1) on the
ground from time to time. This unwinds a
piece of new cutting line from the spool and
cuts off the used line end of the line cutter
(04/2).
6 WORKING BEHAVIOUR AND
WORKING TECHNIQUE (05 – 08)
■
Slightly tip the appliance forwards (approx.
30°) to mow with the tip of the cutting line.
Walk forwards slowly (05).
■
When mowing, swivel the appliance evenly to
the right and left (06).
■
Long grass must be mown in several passes.
Always proceed from top to bottom (07).
■
The appliance cuts best at very high speed.
Therefore, do not overload the appliance by
cutting long grass.
■
If the appliance is overloaded in long grass,
the line will be blocked. Immediately lift the
appliance so it releases. Otherwise, the mo-
tor could be permanently damaged.
■
Do not move the appliance directly against
hard obstacles (e.g. walls), but mow side-
ways. This protects the cutting line (08).
■
Keep the appliance away from sensitive
plants. Fold the protective bracket into the
horizontal position.

7 MAINTENANCE AND CARE

WARNING!
Danger of cutting injuries
Danger of cutting injuries when reaching
into sharp-edged, moving appliance parts
and into cutting tools.
■
Before maintenance, care and clean-
ing work, always switch off the appli-
ance. Remove the rechargeable bat-
tery.
■
Always wear protective gloves during
maintenance, care and cleaning
work.
7.1

Changing the spool (09, 10)

Replacement spool: Art. no. 113349, set of 2.
Precondition: The appliance must be switched off
and the rechargeable battery must be removed
from the basic appliance.
19