Setting Temperature; Steam Ironing; Dry Ironing - Singer SG2030 Mode D'emploi

All manuals and user guides at all-guides.com

SETTING TEMPERATURE

Follow the ironing instructions on the garment label. If there is no instruction then consult
the following table.
Note: If the fabric consists of different threads, always select the temperature required for
the most delicate material.
Fabric
Synthetic
Silk, wool
Cotton, linen

STEAM IRONING

• Place the iron in a vertical position and set the temperature control dial at the minimum
heat setting.
• Insert the plug into the socket, and then turn the temperature control dial to the "high
temperature". The pilot light will turn on, indicating that the iron is heating up.
• When the pilot light turns off, the set temperature has been reached and the iron is ready
to use.
• During ironing, the pilot light on the iron automatically switches on/off as the thermostat
maintains the set temperature (you may continue ironing during this process).
• Turn the steam control turning knob to the required position.
• Steam is produced if the iron in held horizontally.
SPRAYING
Press the spray button to spray water on clothes with stubborn creases.
Note: When using the water spray function, ensure that there is enough water in the water
tank. For the fi rst time, you may need to press the spray button several times in order to start
the spraying function.
BURST OF STEAM
• Press the Burst of Steam Button to generate a powerful burst of steam that can penetrate
the fabrics and smooth the most diffi cult and tough creases. Wait for a few seconds before
pressing again.
• By pressing the Burst of Steam Button at intervals you can also iron vertically (curtains,
hung garments, etc.)
Note: The burst steam function can only be used at the high temperature. Stop the emission
when the pilot light turns on and start ironing again only after the pilot light has turned off.

DRY IRONING

For ironing without steam, follow the instructions in the section "steam ironing", however, the
Steam control knob should remain at the "OFF" position (no steam).
Temperature control
•
• •
• • •
4
ENGLISH
Temperature requirement
Low temperature
Medium temperature
High temperature