Set The Temperature - Singer SteamCraft Manuel D'instructions

Using Your SteamCraft Steam Iron
1. This appliance is designed to use normal tap water. Use of other liquids may damage
the appliance.
2. Plug in the appliance to an appropriate electrical outlet.
3. Start ironing when Mode Light panel stops blinking. This indicates the selected tem-
perature has been reached and the iron is ready for use.
4. Always unplug the appliance after use.
FILL THE WATER TANK
1. Unplug the Power Cord from electrical outlet.
2. Move Steam Selector to the
3. Open Water Tank Door and fill Water Tank with
water (to Max level).
4. Close the Water Tank Door.
5. Plug in Power Cord to electrical outlet and turn
the Temperature Control Dial to the right to
switch on the appliance.
IMPORTANT: Never add fabric conditioner, starches or any other chemicals to water in your
iron. Ensure your iron is switched off and unplugged from electrical outlet before filling.

SET THE TEMPERATURE

The appliance has different temperature settings to handle different fabrics. Turn the
Temperature Control Dial to the right to switch the appliance on. The appliance will start
at Low ( ). If you want to increase the ironing temperature, turn the Temperature
NYLON
Control Dial to the Right and Iron will cycle through the sequence, from "Low (
"Medium (
WOOL/SILK
position.
)" to "High ( )" to "MAX".
LINEN
)" to
NYLON
ENGLISH – 5