Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
E05：Indicate information hint for down-control overcurrent protection of measuring
motor
E05 Solutions to
The treadmill load exceeds the rated
Common
operating current of the motor
Problems
Problems in the assembly structure of
treadmill
resistance or blockage
Fault of down-control Current Limiting
System
E06：Indicate the abnormal phenomenon of low voltage of down-control drive power
supply
E06 Solutions to
The supply voltage is too low
Common
Problems
Failure of down-control Board Routing
Line
E07：The safety lock of the computer has not been put up properly
E07 Solutions to
Safety magnet shedding
Common
Problems
Failure of computer Safety Lock System
and
motor
cause
-25-
Recommended in the rated operating current
range of the motor
Check whether the treadmill structure is normal
motor
Replacement of down-control to be repaired
Please check whether the power supply line is
normal
Replacement of down-control to be repaired
Please place the safety lock at the designated
position of the computer.
Replacement of computer to be repaired
Publicité
Chapitres
Table des Matières
