Publicité
Les langues disponibles
Les langues disponibles
How to work with annular cutters
• Push ejector pin (center pin) through head of annular cutter.
• Turn Rota Quick control ring (Pos. 53) left and insert annular cutter with ejector pin.
• Release control ring and turn annular cutter, until control ring locks the cutter.
• First place annular cutter with ejector pin on a marked center or marking.
• Spot-drill until the entire cut edge is formed as a circle.
Drilling with ALFRA ROTABEST cutters does not require much expenditure of force.
• During the drilling process the cutter should be cooled permanently. Optimal Cooling is possible by
internal cooling with our coolant unit.
• Do not stop the motor during the drilling process. After the process draw the cutter back with running
motor.
• Remove chips and core after each drilling.
Remove chips with chip-remover. Do not touch with bare hands. Danger of injury!
How to work with twist drills.
• The drill chuck is only to be used with twist drills.
• Insert drill chuck with adaptor in the Rota Quick quick change arbor.
• Insert twist drill in drill chuck and tighten.
All manuals and user guides at all-guides.com
14
Publicité
