Elba DREAMline 126 EX 884 Mode D'emploi page 39

INSIDE OF OVEN
This must be cleaned every time it is
used.
Remove and refit the side runner frames
as described on the next chapter.
With the oven warm, wipe the inside
walls with a cloth soaked in very hot
soapy water or another suitable product.
The bottom of the oven (gas oven
cooker only), side runner frames, tray
and rack can be removed and washed
in the sink.
OVEN FITTING OUT
– Hang up the wire racks "G" on the
ovens walls (Fig. 8.1). In the left oven
interpose the catalytic panels "A" (fig.
8.1).
– Slide in, on the guides, the shelf and
the tray etc. fig. 8.2.
The rack must be fitted so that the
safety catch, which stops it sliding out,
faces the inside of the oven (fig. 8.2).
– To dismantle, operate in reverse
order.
Fig. 8.1
All manuals and user guides at all-guides.com
A G
ADVICE FOR USE AND MAINTENANCE
OF CATALYTIC PANELS
Left oven only
The catalytic panels are covered with
special microporous enamel which
absorbs and does away with oil and fat
splashes during normal baking over
200°C.
If, after cooking very fatty foods, the pan-
els remain dirty, operate the oven "idling"
on max temperature for about 30 min-
utes.
These panels do not require to be
cleaned, however it is advised to periodi-
cally remove them from the oven (at
least the side panels) and to wash them
with tepid soapy water and then wipe off
with a soft cloth.
DO NOT CLEAN OR WASH THEM
WITH ABRASIVE PRODUCTS OR
WITH PRODUCTS
ACIDS OR ALKALIS.
The side panels are reversible and when
the catalytic microporous enamel
degrades, they can be turned to the
other side.
CONTAINING
Fig. 8.2
39