Speedlink Strike 2 Mode D'emploi page 21

• Press the macro button, after that the LED will start to flash.
• Now press one of the four shoulder button which you want to assign a
command to.
• Enter your desired command sequence.
• Press the macro button again to end the process. The LED will go
out.
• The selected shoulder button is now programmed with your command
sequence.
• If you want to delete the sequence, press the macro button,
the programmed shoulder button and the macro button again.
Alternatively, simply enter a new button sequence on an already
programmed shoulder button. The previous combination will be
automatically overwritten.
• The Strike gamepad can be programmed to incorporate a time delay.
2
In parallel to pressing the macro button, press the D-Pad upwards.
The command sequence will then be stored with a sequence
interval of 0.03 seconds. The other, slower, interval which can be
programmed (press the D-Pad downwards) is 0.1 seconds.
21