Display And Functions; Alarm Mode - Abus RWM160 Manuel Utilisateur

Display and functions

Always test the functioning of the smoke alarm after installation. Additionally,
a regular inspection is recommended. Ensure your hearing is protected by
maintaining an arm's length distance between yourself and the device!
Audible and visual signals
Low battery
Whenever the battery falls below a certain voltage level, the alarm will sound a
warning signal (every 40 seconds). Whenever the warning signal sounds the alarm
must be immediately replaced with a new one! The alarm has a built-in battery
that cannot be replaced!
From the moment of the first battery warning, the alarm will still operate
at full capability for at least another 30 days!
Self-test with automatic error message
The smoke alarm will perform a periodic self-test and it is able to recalibrate the
sensitivity of the smoke measure chamber automatically in case of contamina-
tion.If the alarm's sensitivity trigger fails under the minimum required threshold
level (e.g. due to excessive contamination of the smoke measure chamber), the unit
will beep once every 40 seconds.
If the error message does not clear upon cleaning of the alarm, then
the alarm should be immediately replaced (see chapter entitled 'Care
and maintenance')!
– 28 –
Mode Audible
Normal operating
-
mode
Low battery beep approx.
every 40 seconds
Electronic test beep 1x per second
(3x), pause of 1,5
seconds
Alarm mute
-
function

Alarm mode

beep 1x per second
(3x), pause of 1,5
seconds
Sensor fault beep approx.
warning every 40 seconds
Buzzer fault
warning
-
Alarm mode
Upon detection of smoke, a loud, pulsating alarm tone will sound and the LED light
will flash simultaneously at short intervals. In this case, proceed as described under
the chapter entitled 'Emergency procedure when alarm sounds'.
Alarm mute function
Once the device is in alarm mode, the alarm sound can be deactivated for 5-15
minutes by pressing the test / stop button.
Audible and visual signals
Visual Note
LED flashes alarm functioning
every 40 seconds
LED flashes Replace alarm
every 40 seconds
LED flashes at
the same time as
alarm sounds
LED flashes every Mute function for
8 seconds 5-15 minutes
LED flashes at See chapter:
the same time as "Emergency proce-
alarm sounds dure when alarm
sounds"
LED flashes Sensor is not func-
every 40 seconds tioning properly,
replace device
LED flashes 2x Buzzer is not func-
every 40 seconds tioning properly,
replace device
– 29 –
GB