Technical Specifications; Product Identification - CAMPAGNOLA T-REX 160-240 Manuel D'utilisation Et D'entretien

3 TECHNICAL SPECIFICATIONS

3.1

Product identification

The identification CE plate/label (Figure 1) is applied to each machine/tool.
The model, serial number and year of manufacture are shown on the manufacturer's CE plate and affixed on the ma-
chine. The CE plate is applied on the machine/tool and shows the data and symbols described below:
1) Conformity marking according to directive 2006/42/EC.
2) Company name and complete address of the manufacturer.
3) The compulsory requirement for all personnel in charge of use and/or maintenance of the tool to read the use and
maintenance manual.
4) Tool designation.
5) Type of tool - Type/code designation of the tool.
6) Serial number.
7) Year of manufacture, i.e. the year in which the manufacturing process was concluded.
8) Information pursuant to Directive "WEEE" 2012/19/EU: Electric and electronic waste may contain hazardous
substances for the environment and human health and therefore must not be disposed of with domestic waste,
they must be collected in dedicated collection centres.
9) Tool supply voltage (only for battery powered electrically supplied tools).
IMPORTANT!
To properly identify the tool, refer to the type, serial number and year of manufacture shown on the identifica-
tion plate and quote them to Campagnola Srl for any service request.
IMPORTANT!
The CE marking is unique and it certifies the conformity of the product with the machinery directive and the
other applicable directives in compliance with the conditions prescribed and shown in this manual.
In case of a "composite" machine/tool, a CE plate/label which identifies the type of tool (e.g. ATRA.xxxx)
composing the composite machine/tool is affixed to the product.
IMPORTANT!
The customer is in charge of checking the integrity of the CE plate/label.
The user must replace the CE and/or warning plates which become illegible due to wear.
It is strictly forbidden to remove the plates/labels on the machine/tool. Campagnola S.r.l declines any respon-
sibility on the safety of the machine/tool in case of non-compliance with this prohibition.
The machine's plate is placed on the machine as indicated in the following figure.
Use and maintenance manual – Instructions
Original instructions Rev.: 00, Date 11/04/2022
Figure 1
Page 35