auna Areal Bar 750 Mode D'emploi page 33

Standby mode.Playback with BT device
This device offers you the possibility to use a BT enabled device. The
functional radius is limited to approx.10 metres depending on the
surroundings and the unit used.
Logging on devices (Pairing)
Before using your speaker with a compatible device, such as a mobile
phone, for the first time, you must pair and connect it to the device.
9. Ensure, that the BT function is activated on your player (e.g. mobile
phone).
10. While in Power On mode, press the Mode button on the main unit or the
BT button on the remote control to select the BT mode. "BT" flashes to
show that the pairing mode is activated.
Pair the Speaker
1. If you haven't paired the speaker with a device, or the paired devices list
is empty, pairing mode is activated.
2. Activate BT on the compatible device, and set it to search for compatible
devices.
3. Select the speaker name: "Areal Bar 750" from the list of found devices.
Note: Only one playback unit can be connected to the speaker. If the
speaker is already connected to another playback unit, the speaker will not
appear in the BT selection list.
4. If your device asks for a passkey [depending on the device
manufacturers, model, and software version], then enter digits
"OOOO"(four zeros) and press OK. If pairing has been carried out
successfully, a prompt sound is heard, meanwhile, the "BT" symbol stops
flashing.
5. After the connection is complete, you can listen to music wirelessly
through BT and select music from your BT device.
6. Press the / buttons on the remote control or the"+"/"-" buttons on
the main unit to raise/lower the volume level.
7. To disconnect the BT function, switch to another function on the unit or
disable the function from your BT device.
Tips:
1. If a mobile phone on which you are playing music receives a call, the
music will be interrupted. The sound however is not played back via the
speaker. After you have ended the call, the devices are connected to
each other again and playback continues.
2. If there is an existing connection, press and hold the BT button on the
EN
33