Operation - auna Areal Bar 750 Mode D'emploi

EN
32

OPERATION

Power on/standby 8c pairing the subwoofer to the sound bar at the first
time use
Before connecting the AC power, ensure that the power supply voltage
corresponds to the voltage printed on the back or the underside of the unit.
1. Insert the DC plug of the AC-DC power adaptor into the DC IN jack
on the back of the main unit, then connect the AC-DC adapter to a
convenient wall outlet.
2. Press the O button to switch the sound bar on. The LED display will light
up and show the current playback mode.
3. Plug the plug of subwoofer into the main power supply.
4. Press the Power On/Off Switch on the back of the subwoofer to "ON"
position to turn it on, the subwoofer will wirelessly connect with the
sound bar automatically, the Wireless Pairing Indicator changes to
steady red once the connection is carried out successfully.
Note: Only one playback unit can be connected to the speaker. If the
speaker is already connected to another playback unit, the speaker will not
appear in the BT selection list.
5. If your device asks for a passkey [depending on the device
manufacturers, model, and software version], then enter digits
"OOOO"(four zeros) and press OK. If pairing has been carried out
successfully, a prompt sound is heard, meanwhile, the "BT" symbol stops
flashing.
6. After the connection is complete, you can listen to music wirelessly
through BT and select music from your BT device.
7. Press the / buttons on the remote control or the"+"/"-" buttons on
the main unit to raise/lower the volume level.
8. To disconnect the BT function, switch to another function on the unit or
disable the function from your BT device.
Select different input mode
Press the Mode button repeatedly on the main unit or press Mode button
on the remote control to select relevant input mode.
Notes:
• The LED display will go off automatically if the sound bar is sitting idle
during any playback mode or there is no input signal received for about
3 minutes, press any button once to light up the display again.
• When the sound bar is sitting idle and no input signals are being
received for about 15 minutes, the sound bar will automatically switch to