Dea REV Notice D'emploi Et Avertissements page 29

5 How to adjust the limit switche
1. Scroll down the parameters untill you visualize
P001;
2. confirm by pressing the
3. by pressing (OPEN) and
leaf in the opening position and adjust the limit
switch cam so that it pushes the microswitch in that
point;
Repeat adjusting the closing limit switch.
4. Confirm by pressing the key (display shows again
P001).
6 Motor stroke learning
1. Make sure you have properly adjusted the opening/closing limit switches cams;
2. Scroll down the parameters with
3. Access the parameter by pressing the
4. When " " flashes, continue pressing the
5. Release the key when "
6. Wait for the door searches and stops on the opening stop and then on the closing stop.
7. Once the procedure is ended, the display will show "- - - - ".
7 Transmitters learning
7.1 Transmitters coding selection
1. Scroll down the parameters with
P027;
2. Confirm by pressing on the
3. Select the type of transmitter by scrolling
- d000=fix rolling-code (suggested);
- d001=complete rolling-code;
- d002=dip-switch;
4. Confirm by pressing on the
Warning: If you need to vary the type of encoding, and only if other remo-
tes with different encoding are memorized, you need to erase memory
(P004) AFTER you have set the new encoding.
7.2 Learning
1. Scroll down the parameters with
keys until you visualise P005;
2. Confirm by pressing on the
3. When the symbol " " appears, press on
any key of the transmitter you want to memo-
rize;
4. The display visualizes the number of the trans-
mitter just memorized and then "
5. Memorize all necessary transmitters repeat-
ing this procedure from step 3;
6. Wait 10 seconds before quitting the memori-
zation mode, display shows now "- - - - ".
Warning: In the case of rolling code remotes,
the receiver can be put into learning mode by
pressing the hidden button on a remote control
previously learned.
All manuals and user guides at all-guides.com
key;
(CLOSE), move the
and keys until you visualise P003;
key;
key;
" stops flashing; Start the learning procedure with operator 1 opening;
and keys until you visualise
key;
and keys:
key (display shows again P027).
and
key;
";
27