Searching For Errors - Waeco MagicWatch MWE650 Instructions De Montage Et De Service

MWE-650-4DSM.book Seite 43 Dienstag, 16. Mai 2006 4:42 16
All manuals and user guides at all-guides.com
MagicWatch MWE650
9 Maintaining and cleaning MagicWatch
Caution!
Do not use sharp or hard objects to clean the device as these may
damage the sensors.
➤ Clean the sensors with a damp cloth from time to time.
10

Searching for errors

The device indicates no function.
The cables to the reversing light are not connected or are switched.
The plug for the display is not connected or is not properly plugged into the
control electronics.
The plugs for the sensors are not connected or are not properly plugged into
the control electronics.
➤ Check the plugs, and plug them in so that they latch in place.
A defective sensor is indicated (three beeps when you engage reverse
gear)
If a defective sensor is indicated (see "Testing functions"chapter on
page 41), this is what to do:
➤ Park the vehicle about a metre away from a large obstacle, such as a
garage door.
➤ Engage reverse gear.
✓ The slow beeps sound (Zone 1, see fig. 5, page 5) and the green LEDs of
the intact sensors light up.
➤ Then stand in front of each sensor in succession.
✓ The beeps speed up. The beeps do not change on the defective sensor.
Maintaining and cleaning MagicWatch
43