Waeco MagicWatch MWE650 Instructions De Montage Et De Service page 38

MWE-650-4DSM.book Seite 38 Dienstag, 16. Mai 2006 4:42 16
All manuals and user guides at all-guides.com
Installing MagicWatch
Make sure the locking pin catches (see fig. 13 A, page 6). Only then is
trouble-free operation guaranteed.
To release the connection press the holder and pull the plug and socket
apart (see fig. 13 B, page 6).
If the sensor cable is not long enough, you can order one-metre extension
cables (MWCS-1) as accessories.
Note
The extension cables are marked: L (left), CL (centre left),
R (right), CR (centre right).
This marking helps you connect them to the control electronics to
ensure that the display is correct.
Caution!
Before making any drill holes, ensure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
➤ Take suitable precautions to protect holes made in the bodywork from
water penetration, for example by spraying the cable and the sleeve with
sealant.
➤ Where possible, use existing rubber bungs in the boot for laying the
extension cables.
If there are no rubber bungs, make a suitable hole with a diameter of
around 13 mm and insert a cable sleeve.
Note
Pull the plugs of the extension cables through the cable sleeve
before inserting the sleeve in the body work.
➤ Lay out the cables so that they cannot be damaged under any circum-
stances (e.g. by flying grit).
➤ Carefully fasten the extension cables behind the bumper.
➤ Insert the sensor plugs into the sockets of the corresponding extension
cables (see fig. 15 A, page 7).
38
MagicWatch MWE650