Burkert 8222 ELEMENT neutrino Manuel Utilisateur page 28

Type 8222 ELEMENT neutrino
Installationandwiring
B
Fig. 12: Installation of the transmitter in a fitting
All manuals and user guides at all-guides.com
→
C h e c k t h e
presence and the
condition of seal
B on the fitting.
Replace the seal if
necessary.
→
I n s e r t t h e
transmitter carefully
into the fitting.
→
Position the trans-
mitter in such
a way that the
markings (see
zoom) located on
either side of the
electronics box
are parallel to the
pipe.
→
Tighten the fas-
tening nut by
hand.
english
8.2.2. installation of a transmitter with a
G 3/4" external threaded sensor
→
Check if the seal is fitted on the threaded sensor.
→
Check the condition of the seal and replace it if necessary (see
§ 11.4).
→
Install the device on the pipe or the tank wall by means of a
G 3/4'' internal threaded S022 adapter or another fitting res-
pecting the threading jig from Fig. 13.
Ø 27,5
G3/4''
Ø 24 min.
minimal internal thread depth
1)
Fig. 13: Threading jig for the adapter [mm]
→
Install the transmitter into the fitting/adapter.
→
Position the transmitter in such a way that the markings (see zoom
in Fig. 12) located on either side of the electronics box are parallel
to the pipe.
H8
R 0,25 min.
23