NSK NLX nano Mode D'emploi page 3

· Verify that the Speed Control Switch is adjusted within the allowable speed before use.
· Air Requirements: dry, free from contamination and oil. Use a compressor with a dry air system. Install an air filter if
necessary. Blow out the lines before installation.
· Do not Autoclave ( or any other high temperature Sterilization ) Motor Cord.
· The user shall be responsible for operation and maintenance.
· The operator is responsible for correct operational control, maintenance and inspection.
· Surface temperature shall be more 60°C without using a coolant air, to avoid this event, be sure to use coolant air.
2