Automatic Closing - CAME BXL Serie Manuel D'installation, D'utilisation Et D'entretien

TOTAL STOP from button (contact 1-2)
By default, the feature is enabled.
To disable it:
select the DIP switches as shown and press the P1 key on the control board. The LED blinks and the
buzzer sounds off twice.
To return to the default parameters, press P1 again. The LED stays lit and the buzzer sounds off for 1
second.
Self-learningof the gate-leaf travel
Select the DIP switches as shown and press the P1 key on the control board.
The gate will perform a series of maneuvers to determine the endstop slow-down points.
During calibration the red LED blinks. Once the calibration is complete, the buzzer sounds off for 1
second.
If the calibration has not succeeded, the LED blinks quickly and the buzzer sounds off 4 times.
You can interrupt the gate travel's self-learning operation by pressing key P1.
Input on contact 2-CX
By default,the feature is disabled.
To enable it:
select the DIP switches as shown and press the P1 key on the control board. The LED stays on and the
buzzer sounds off for one second.
To return to the default setting, press P1 again. The LED blinks and the buzzer sounds off twice.
Reopening during closing or obstruction wait (contact 2-CX)
By default, the feature is set to reopening during closing.
To enable on obstruction wait:
select the DIP switch as shown and press the P1 key on the control board. The LED stays on and the
buzzer sounds off for one second.
To return to the default settings, press P1 again. The LED blinks and the buzzer sounds off twice.
Self-learningof the partial gate-travel
Using the control button (7) on the control board, take the gate to the desired partial opening position.
Select the DIP switches as shown and press the P1 key on the control board. The LED stays on and the
buzzer sounds off for one second.
To return to the default setting, press P1 again. The LED blinks and the buzzer sounds off twice.
If the partial opening is not within the minimum and maximum limits set by default, the LED
blinks quickly and the buzzer sounds off 4 times.
OPEN-CLOSE-INVERT or OPEN-STOP-CLOSE-STOP with button (contact 2-7)
By default, the feature is OPEN-CLOSE-INVERT.
To enable it to OPEN-STOP-CLOSE-STOP:
select the DIP switches as shown and press the P1 key on the control board. The LED stays on and the
buzzer sounds off for one second.
Toreturn to the default settings, press P1 again. The LED blinks and the buzzer sounds off twice.

Automatic closing

By default, the feature is disabled.
To enable it:
select the DIP switches as shown and press the P1 key on the control board. The LED stays on and the
buzzer sounds off for one second.
Toreturn to the default setting, press P1 again. The LED blinks and the buzzer sounds off twice.
The wait before the automatic closing starts when the opening limit-switch point is reached - for a time
that is settable on the A.C.T. trimmer.
⚠ The automatic closing does not activate if the safety devices are triggered due to obstacle detection,
after a total stop or if the power supply is missing.