Hendi MACHINE PROFI LINE 410 Mode D'emploi page 8

Operation
• Select the proper size of vacuum bag. (Bag width
of 400mm). Allow a minimum of 3 ~ 4 cm of extra
spacing at the top to ensure well sealing.
• With the lid (1) kept open, insert the power cord
to the socket at the rear of the machine and the
power plug to a suitable electrical power outlet.
• Then, turn the ON / OFF switch clockwise to the
"ON " position. "ON " will be shown on the digital
display (D).
• Next, press SET button (A) to select the VACU-
UM TIME, SEALING and COOLING process for
setting.
• Then, press increase / decrease button (B) to ad-
just the time of each process.
See below for the setting range of different oper-
ations:
1) Vacuum Time: 5 ~ 90 seconds (With 5 seconds
interval)
2) Seal Time: Set up to 6 seconds (With 0,5 second
interval, descending)
3) Cooling Time: Set up to 10 seconds
• Put the food in a vacuum bag. Then, put the whole
bag under the fixing clamp (9) inside the chamber
EN
(10) of the machine.
• Please make sure that the opening of the vac-
uum bag is entirely and properly under the seal
bar (8) for sealing. And the whole vacuum bag is
locked properly by the fixing clamp (10) inside the
chamber (9).
• Close the lid (1) and put up the lid lock (2). The
machine will start vacuum-and-seal process au-
tomatically.
8
• After that, VACUUM TIME indicator (G) will blink
in blue and the machine will start countdown to
show the remaining time on the display (D).
• Similarly, SEALING & COOLING indicator (G)
will blink in blue and the machine will start the
countdown. Remaining time of sealing and cool-
ing process will be shown on the display (D).
• Now, air inside the vacuum bag and chamber is
sucked out (9).
• A beep will sound when the sealing process is
finished.
• "CLO" will be displayed on the display (D) for 15
seconds. After that "ON " will be shown on the
digital display (D).
• Put down the lid lock (2) to open the lid (1) and
take away the packaged food.
Note:
1) When the machine is under "vacuum" process,
you can press "STOP" button (C) to switch to
"sealing" process instantly.
2) When the display shows "CLO", the machine is
in idle mode. In this mode, no matter which but-
ton you press, the machine will not work. Just
put down the clamp lock (2) and open the lid (1).
Then, the machine can return to normal oper-
ation.
3) After the process, check the completeness of the
sealing. If the seal is not correct, adjust the vac-
uum and sealing time.