Lighting Instructions - Klarstein LUCIFER Mode D'emploi

EN

LIGHTING INSTRUCTIONS

Caution
The lid must be open when lighting the burner!
Do not stand with your face directly over the gas grill when lighting it.
Your gas grill will have following method of ignition:
Pilot Gas Control Ignition(Main burner or main burner with side burner or main
burner with side burner and back burner)
With all gas controls on the Gas grill in the "OFF" position "OFF", turn the gas cylinder
valve to the on position at the regulator. To create a spark you must press the gas
control knob (A) and hold in this position for 3-5 seconds to allow gas flow and then
turn anticlockwise to "HI" (B). It can spark to the burner lighting tube (C). You will hear
a "snap" from the igniter and you will also see a orange flame coming from the burner
lighting tube at the left side of the burner (D).
Continue to hold the gas control knob in for two seconds after the "snap", this will allow
gas to flow completely down the burner tube (E) and insure ignition.
When the burner is alight, adjacent burners will cross light when their controls are turned
to "HI".
At "HI" setting the burner flame should be approximately 12-20 mm long with a
minimum of orange flame. Turn the gas control knob fully anticlockwise for minimum
setting.
Should you have any difficulty lighting your gas grill following the above steps, contact
your dealer for advice.
If the automatic ignition can't be used, please remove the cooking grill and heat
diffuser(hotplate ), and turn the valve anticlockwise to 90° to light with BBQ lighter in
the distance of 5 mm to the burner fire hole. Replace the cooking grill and heat diffuser
(hotplate), please wear the fireproof and heat resisting gloves.
27