Installation - SOMFY HOME MOTION Tilt 50 RTS Notice

2.1. iNSTallaTiON

2.1.1. Shaft adaptation
1) Slide shaft to far side of the headrail until
is 9cm / 3.54In from the end.
2) If shaft does not slide 9cm / 3.54In from
the end, mark and cut shaft to remove 9cm
/ 3.54In from the end of the headrail (use
motor to measure mark).
If needed, file the end of the shaft to
remove any rough edges.
2.1.2. motor preparation
1) Put the motor into the appropriate headrail
adaptor and secure snaps on top of motor.
2) If needed, press the shaft adaptor into the
motor.
2.1.3. motor/headrail assembly
Position the blind to be fully open
(horizontal).
Slide the motor into the headrail until the
shaft is fully inserted into the motor.
Copyright © 2015 Somfy SAS. All rights reserved - V1 - 03/2015
1)
9 Cm / 3. 5 4 I n
2)
9 Cm / 3. 5 4 I n
1)
2)
5