Handling And Transport; Warranty Coverage; Assistance And Repairs - GGP ITALY B 26 J Manuel D'utilisation

10. HANDLING AND TRANSPORT

Whenever the machine is to be
handled or transported, you must:
– turn off the engine;
– wait for the cutting means to
come to a complete stop
– disconnect the spark plug
cap (fig. 10.H; fig. 11.H)
– apply the blade protection device
– only hold the machine using the
handgrips and position the cutting
means in the opposite direction to
that used during operations.
• When using a vehicle to
transport the machine:
– position it so that it can cause
no danger to persons;
– fasten it firmly in place to avoid
it from tipping over, which may
cause damage or fuel spillage.

11. ASSISTANCE AND REPAIRS

This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can
be performed by the user. Any regulations
and maintenance operations not described
herein must be carried out by your Dealer
or Authorized Service Centre, which have
the necessary knowledge and equipment to
ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Any operations performed in unauthorized
centres or by unqualified persons will totally
invalidate the Warranty and all obligations
and responsibilities of the Manufacturer.
• Only authorized service workshops can carry
out guaranteed repairs and maintenance.
• The authorized service workshops
only use genuine spare parts. Genuine
spare parts and accessories have been
designed specifically for machines.
• Non-genuine spare parts and accessories
are not approved. Using non-genuine spare
parts and accessories voids the warranty.
• It is advisable to send your machine
once a year to an authorized service
workshop for servicing, assistance
and safety device inspection.

12. WARRANTY COVERAGE

The warranty covers all material and
manufacturing defects. The user must
follow all the instructions provided in
the accompanying documentation.
The warranty does not cover damage caused by:
• Failure to familiarise oneself with the
documentation accompanying the machine.
• Carelessness.
• Incorrect or prohibited use or assembly.
• Use of non-genuine spare parts.
• Use of accessories not supplied or
approved by the manufacturer.
The warranty does not cover:
• Normal wear and tear of consumables,
such as cutting means, safety bolts.
• Normal wear and tear.
The purchaser is protected by his or her own
national legislation. The purchaser's rights under
the national laws or his or her own country are
not in any way restricted by this warranty.
EN - 14