Renkforce 808576 Notice D'emploi page 60

All manuals and user guides at all-guides.com
Function „TV Out"
The video standard of the AV output can be switched between PAL and NTSC.
Proceed as follows:
• Use the buttons „4" and „6" to pick the function „TV Out" and then push „
• Use the buttons „4" and „6" to switch between „NTSC" and „PAL".
• Confirm the selection with „
• If required, push the button „MENU" repeatedly to return to the respective previous menu or to leave the
OSD menu.
Function „Version"
The firmware version of the screen/DVR and all registered radio cameras can be displayed here.
Proceed as follows:
• Use the buttons „4" and „6" to pick the function „Version" and then push „
• The screen now shows the firmware version of the screen/DVR („TX") and the registered radio cameras
(„CAM1".... „CAM4").
• If required, push the button „MENU" repeatedly to return to the respective previous menu or to leave the
OSD menu.
Function „Zoom"
Activate a digital zoom with this to indicate the video display of the radio camera twice as large. If the
enlarged image of the radio camera is displayed, you can move the visible image section with the four
arrow buttons.
Proceed as follows:
• Use the buttons „4" and „6" to pick the function „Zoom" and then push „
• Use the buttons „4" and „6" to switch between „x1" (normal display) and „x2" (zoom).
• Confirm the selection with „
• If required, push the button „MENU" repeatedly to return to the respective previous menu or to leave the
OSD menu.
The volume cannot be set in zoom mode, since the arrows are used to move the visible section
of the screen here. Briefly switch to the quad or auto mode (see chapter 10 e) and then set the
volume as desired.
Function „Upgrade"
This function is used to perform a firmware upgrade by the manufacturer.
If there is a firmware upgrade available for the screen/DVR, it is provided at www.conrad.com on the res-
pective product page with a description for the precise procedure.
60
".
".
".
".
".