Renkforce 808576 Notice D'emploi page 54

All manuals and user guides at all-guides.com
c) Submenu „Camera Setup"
In the OSD menu, use the buttons „4" and „6" to select the submenu „Camera Setup" and push the
button „ ".
Function „Activation"
Unused channels can be switched off here, e.g. when using only two radio cameras/channels (the screen/
DVR permits use of up to four radio cameras/channels). In single-quad or auto mode (see chapter 10. e),
the deactivated channels are not displayed.
Example: If you use two radio cameras and use the Auto mode, channels 1 and 2 will be displayed alteran-
tingly. The un-assigned channels 3 and 4 (which would only show a black screen) are not displayed.
Proceed as follows:
• Use the buttons „4" and „6" to pick the function „Activation" and then push „
• Use the buttons „8" and „2" to select one of the four channels („CAM1", „CAM2", „CAM3" or „CAM4";
it is marked yellow each.
• Push the button „
• Switch the channel on or off with the buttons „4" and „6" („ON" = switched on, „OFF" = switched
off).
• Confirm the setting with „
• If required, push the button „MENU" repeatedly to return to the respective previous menu or to leave the
OSD menu.
Function „Brightness"
In this function, the screen brightness for each radio camera/channel can be set separately.
Proceed as follows:
• Use the buttons „4" and „6" to pick the function „Brightness" and then push „
• Use the buttons „4" and „6" to pick one of the four channels now.
• Push „ " to display the camera image of the respective channel.
• Set the desired brightness with the buttons „4" and „6".
• If required, push the button „MENU" repeatedly to return to the respective previous menu or to leave the
OSD menu.
54
" to change the mark from yellow to red.
".
".
".