Festool CTM 26 E Notice D'utilisation D'origine page 16

► Open the locking clips [2-2] and remove the
top section of the machine [2-1].
► Remove the accessories from the dust con­
tainer [2-3] and the packaging!
► Insert a filter or disposal bag in the dirt trap
(see chapter 7.7 and
► Replace the top section [2-1] and close the
locking clips [2-2].
► Attach the cable holder to the rear of the
mobile dust extractor (see Fig. [3]).
► Connect the suction hose to the machine.
6.2 Switch on/off
► Insert the plug into an earthed socket.
WARNING
Risk of injury from tools starting up unex­
pectedly
► Before setting the switch to the "AUTO" or
"MAN" position, make sure that the con­
nected tool is switched off.
The switch [1-11] serves as an on/off switch.
Switch position "0"
Appliance socket [1-4] is disconnected from the
power, mobile dust extractor is switched off.
"MAN" switch position
Appliance socket [1-4] is connected to the pow­
er, the mobile dust extractor starts.
"Auto" switch position
Appliance socket [1-4] is connected to the pow­
er, the mobile dust extractor starts when the
connected tool is switched on.
7 Settings
7.1 Adjusting the hose diameter
► Adjust the hose diameter adjuster [1-9] to
match the diameter of the connected hose.
The monitoring devices will measure
the air speed in the extractor hose
correctly as a result (see chapter
7.9 ).
16
All manuals and user guides at all-guides.com
7.8 ).
7.2 Connecting electric power tools
WARNING
Risk of injury
► Observe the maximum appliance socket
connected load (see chapter "Technical da­
ta")
► Switch off the electric power tool.
► Connect the electric power tool to the appli­
ance socket [1-4].
7.3 Connecting pneumatic tools
WARNING
Risk of injury
► Switch off the air tool.
Automatic on/off switch for air tools (CTM 36 E
LE, CTM 36 E LE AC, CTM 48 E LE, CTM 48 E LE
AC or accessories)
with compressed air module in module slot
[1-3]
Recommendation:
– Attachment of service unit VE (495886):
compressed air filtered and lubricated
– Use of IAS system with IAS connector
(454757) for Festool air tools
Requirement: tool with operating pressure of
6 bar!
7.4 Adjusting the suction power
► Use the rotary knob [1-10].
7.5 Applying the brake
Folding out the black brake lever [1-15] pre­
vents the mobile dust extractor from rolling. To
achieve this, lift the front end of the mobile dust
extractor slightly and push the black brake lev­
er downwards until it latches into place. Push
the green lever [1-14] again to release.
7.6 Temperature cut-out
To prevent overheating, a temperature cut-out
switches the mobile dust extractor off when it
reaches a critical temperature.
► Switch off the mobile dust extractor and al­
low to cool for about 5 minutes.
If the mobile dust extractor will not
switch on again, please contact a Fes­
tool service workshop.
English