Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To switch between upper and lower case letters
Click CAPS.
If you make a mistake
Click ? or / to move the cursor to the character to be
changed, then click the correct character (or click the
space bar to erase the character).
5
After entering the name, click RETURN to go back
to the USER IR CODE SETTING menu.
Repeat steps 3 through 5 until you enter the
names of all the IR codes you want to program.
6
Click the name of the first IR code.
USER IR CODE SETTING
LIGHT 1
LIGHT 2
LIGHT 3
LIGHT 4
RETURN
Before going to step 7, cover the IR sensor on the
respective equipment to prevent accidental
operation during the programing procedure.
7
Click on START.
When "PUSH YOUR COMMANDER" appears on
the TV screen, press the button you want to
program.
USER IR CODE SETTING
LIGHT 1
LIGHT 2
LIGHT 3
LIGHT 4
PUSH
YOUR
RETURN
When programing the IR code, point the remote
at the IR sensor on the receiver from a distance no
greater than 10 cm and hold down the button on
the remote for about 5 seconds until the
instruction "RELEASE YOUR COMMANDER"
appears and the IR code setting indicator turns
off.
IR sensor
All manuals and user guides at all-guides.com
A
B
C
D
EXIT
A
B
C
D
INDEX
START
COMMANDER
CODE CLEAR
EXIT
Preparing and Using the Remote
Keep the remote pointed horizontally at the IR
sensor until the code is programed.
If you tilt or move the remote during the
programing procedure, the IR code may not be
programed correctly.
Repeat this procedure for the remaining buttons
After you've programed all the IR codes, the IR CODE
SETTING menu reappears.
To reprogram a specific IR code.
Click the button where the IR code was programed, then
click START.
To Erase IR codes
Click CODE CLEAR.
• To erase one specific IR code
1 Click SINGLE IR CODE CLEAR
2 Click the button you want to clear.
"Are you sure?" appears for confirmation.
3 Click YES to erase the code.
"CODE CLEAR!" appears in the display.
To stop before erasing a code, click NO.
To erase another code repeat steps 2 and 3.
• To erase all the user IR codes.
1 Click USER IR CODE CLEAR.
"Are you sure?" appears for confirmation.
2 Click YES to erase the codes.
"CODE CLEAR!" appears in the display.
To stop before erasing the codes, click NO.
• To all the IR codes.
1 Click ALL IR CODE CLEAR.
"Are you sure?" appears for confirmation.
2 Click YES to erase the codes.
"CODE CLEAR!" appears in the display.
To stop before erasing all the codes, click NO.
Notes
• Even if the receiver's power cord has been disconnected
from the AC power outlet, programed IR codes will stay
in the memory for approximately two weeks. If they
disappear, "ALL CLEAR" will appear on the TV screen
when you turn on the unit again.
• The power switch on some air conditioners use two
independent IR codes, even when there is only one switch.
If you cannot turn the air conditioner off with the IR code
programed for the on/off switch, repeat the procedure
and program the on and off IR codes separately.
• The operation of some air conditioner remote commanders
require two–way signal exchange with the air conditioner
itself. Though it is possible to program the IR codes of
such remote commanders in the unit, their use may not
result in normal air conditioner operation.
• The unit may not be able to register IR codes with special
waveforms produced on some remote commanders.
23
EN
Publicité
Table des Matières
